Proxim AP-4000 User Manual page 146

Hide thumbs Also See for AP-4000:
Table of Contents

Advertisement

Advanced Configuration
SSID/VLAN/Security
Strict: MAC ACL settings are enabled. If a higher-priority authentication protocol is also enabled, MAC ACL
settings will be applied in addition to the higher priority authentication protocol settings. See
Protocol
Hierarchy. When MAC ACL Status is set to Strict, changes to the MAC ACL table (configured on the
MAC Access
page) will take effect without a device reboot.
5. Enter Rekeying Interval in seconds (between 300 and 65525). When set to 0, this parameter is disabled. The default
is 900 seconds.
6. Enter the Security Profile used by the VLAN in the Security Profile field. See the
information.
7. Define the RADIUS Server Profile Configuration for the VLAN/SSID:
RADIUS MAC Authentication Profile
RADIUS EAP Authentication Profile
RADIUS Accounting Profile
If 802.1x, WPA, or 802.11i security mode is used, the RADIUS EAP Authentication Profile must have a value.
A RADIUS Server Profile for authentication for each VLAN shall be configured as part of the configuration options
for that VLAN. RADIUS profiles are independent of VLANs. The user can define any profile to be the default and
associate all VLANs to that profile. Four profiles are created by default, "MAC Authentication", "EAP
Authentication", Accounting", and "Management"
8. If desired, scroll down to the scroll down to the SSID and VLAN Table and click Edit to modify the Network Name,
VLAN ID, or QoS profile of the SSID/VLAN.
NOTE: Because VLAN tagging is disabled, attempting to add a new SSID/VLAN will produce an error message.
The Edit Entries screen will be displayed. See
Figure 4-64 SSID/VLAN Add Entries Screen (VLAN Tagging Disabled)
9. Enter a unique Network Name (SSID) between 1 and 32 characters. This parameter is mandatory.
NOTE: Do not use quotation marks (single or double) in the Network Name; this will cause the AP to misinterpret the
name.
10.Select Enable or Disable from the dropdown list to enable/disable CMOB status. The default is Disable.
Figure
4-64.
AP-4000/4000M/4900M User Guide
Authentication
Security Profile
section for more
146

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ap-4000mOrinoco ap-4000

Table of Contents