Proxim AP-4000 User Manual page 49
Hide thumbs
Also See for AP-4000:
- User manual (270 pages) ,
- Specification sheet (2 pages) ,
- Configuration manual (6 pages)
Table of Contents
Advertisement
Advanced Configuration
Network
Figure 4-4 DHCP Server Configuration Screen
You can configure and view the following parameters within the DHCP Server Configuration screen:
NOTE: You must reboot the AP before changes to any of these DHCP server parameters take effect.
•
Enable DHCP Server: Place a check mark in the box provided to enable DHCP Server functionality.
NOTE: You cannot enable the DHCP Server functionality unless there is at least one IP Pool Table Entry configured.
•
Subnet Mask: This field is read-only and reports the Access Point's current subnet mask. DHCP clients that receive
dynamic addresses from the AP will be assigned this same subnet mask.
•
Gateway IP Address: The AP will assign the specified address to its DHCP clients.
•
Primary DNS IP Address: The AP will assign the specified address to its DHCP clients.
•
Secondary DNS IP Address: The AP will assign the specified address to its DHCP clients.
•
Number of IP Pool Table Entries: This is a read-only field that reports the number of entries in the IP Pool Table.
•
IP Pool Table Entry: This entry specifies a range of IP addresses that the AP can assign to its wireless clients. Click
Add to create a new entry. Click Edit to change an existing entry. Each entry contains the following fields:
–
Start IP Address: The first IP address in the pool. IP addresses must be within the same subnet as the AP.
–
End IP Address: The last IP address in the pool. IP addresses must be within the same subnet as the AP.
–
Default Lease Time (optional): The default time value for clients to retain the assigned IP address. DHCP
automatically renews IP Addresses without client notification. This parameter supports a range between 3600 and
86400 seconds. The default is 86400 seconds. If this field is left blank, the default (86400) is used.
–
Maximum Lease Time (optional): The maximum time value for clients to retain the assigned IP address. DHCP
automatically renews IP Addresses without client notification. This parameter supports a range between 3600 and
86400 seconds. The default is 86400 seconds. If this field is left blank, the default (86400) is used.
AP-4000/4000M/4900M User Guide
49
Advertisement
Table of Contents
