Proxim AP-4000 User Manual page 136

Advanced Configuration
SSID/VLAN/Security
2. Set the VLAN Management ID to use the same VLAN ID as one of the configured SSIDs.
3. Place a check mark in the Enable VLAN Tagging box.
Disable VLAN Tagging
1. Click Configure > SSID/VLAN/Security > Mgmt VLAN.
2. Remove the check mark from the Enable VLAN Tagging box (to disable all VLAN functionality) or set the VLAN
Management ID to -1 (to disable VLAN Tagging only).
NOTE: If you disable VLAN Tagging, you will be unable to configure security per SSID.
Uplink VLAN ID Table
The AP has a table for configuring the VLAN IDs that are manually/statically inserted by the user. The list contains the
VLANs that are known to exist on the Ethernet interface of the AP.
This list is used by the ProximUnify System to ascertain whether VLAN mobility needs to be provided to a certain CMOB
Enabled STA after it roams to another AP.
It is always recommended that:
• All the VLANs which are known to exist on the uplink are configured in the Uplink Table; OR
• Of all the VLANs available on the Uplink, at least configure the VLANs (in the Uplink Table) which are
used/configured on any of the CMOB-enabled SSIDs in the whole Wireless Domain.
To Add Uplink VLAN Configuration
1. Click the ADD button. A new interface is displayed.
2. Enter the values in the Start VLAN ID and End VLAN ID fields.
3. Click OK.
Figure 4-57 To add uplink VLAN configuration interface
To Edit Uplink VLAN Configuration
1. Click the EDIT button. The following interface is displayed.
2. Reset the values in the Start VLAN ID and End VLAN ID fields.
3. To enable status server, select Enable from the dropdown list.
4. Click OK.
The updated values are reflected in the Uplink VLAN table.
AP-4000/4000M/4900M User Guide
136