Memory Installation - SOLTEK SL-65KIV User Manual

65KIV/KIV2

2-2 MEMORY INSTALLATION

WARNING!!!
• Make sure to unplug your power supply before adding or removing memory
modules or other system components. Failure to do so may cause severe
damage to both your mainboard and expansion cards.
• Be careful when inserting or removing DIMM. Forcing a DIMM in or out
of a socket improperly may damage the memory module or the socket.
Some DIMMs which contain EDO or FPM DRAM are incompliant with
the mainboard. The M/B supports 3.3V true SDRAM DIMMs only.
Installing DIMM
• Make sure you have the correct memory module type for your mainboard.
• Insert the module(s) as shown below, DIMMs have 168-pins and two
notches that will be matched by the onboard DIMM socket. Memory
modules are installed by inserting them straight into the slot until they
"click" in the right place. They only fit in one direction, so do not force
them in by a wrong direction.
168-Pin DIMM Notch Key Definitions(3.3V)
Removing DIMM
• Press down the holding clips on both sides of a DIMM socket and the
module will be released from it.
DRAM Key Position Voltage Key Position
Unbuffered
20
3.3V