Multicast Paging - Yealink SIP-T20 User Manual

User Guide for the SIP-T20P/SIP-T20 IP Phone
Int ercom Tone
You can enable or disable the phone to play a warning tone when receiving an
intercom call. If Intercom Tone is enabled, the phone plays a warning tone before
answering the intercom call. If Intercom Tone is disabled, the phone automatically
answers the intercom call without warning. Intercom Tone is enabled by default.
Int ercom Barge
You can enable or disable the phone to automatically answer an incoming intercom call
while there is already an active call on the phone. If Intercom Barge is enabled, the
phone automatically answers the intercom call and places the active call on hold. If
Intercom Barge is disabled, the phone handles an incoming intercom call like a waiting
call. Intercom Barge is disabled by default.
You can use multicast paging to quickly and easily forward time sensitive
announcements out to people within the multicast group. You can configure a multicast
paging key on the phone, which allows you to send a Real Time Transport Protocol (RTP)
stream to the pre-configured multicast address(es) without involving SIP signaling. You
can configure the phone to receive an RTP stream from pre-configured multicast
listening address(es) without involving SIP signaling. You can specify up to 10 multicast
listening addresses.
To configure a multicast paging key via phone user interface:
1. Press
2. Select F e atures->DSS Keys.
3. Select the desired DSS key.
4. Press
5. Press
6. Enter the multicast IP address and port number (e.g., 224.5.6.20:10008) in the Value
field.
The valid multicast IP addresses range from 224.0.0.0 to 239.255.255.255.
7. Press
86
.
or to select Ke y Event from the Ty pe field.
or to select Multi-Paging from the Ke y Type field.
2. Key Type:
◄ Multi-Paging ►
to accept the change.