Yealink SIP-T20 User Manual page 28

User Guide for the SIP-T20P/SIP-T20 IP Phone
To configure PPPoE via phone user interface:
1. Press
2. Select Se ttings->Advanced (password: admin) ->Ne twork->WAN Port.
3. Press
4. Press
5. Enter the user name and password in the corresponding fields.
6. Press
Not e
Wrong network se ttings may result in inacce ssibility of yo ur phone and may also have an
impact on your network performance. For more information on these parameters,
contact your system administrator.
Generally, your phone will be deployed with multiple other phones. In this case, your
system administrator will configure the phone parameters beforehand, so that after you
start up your phone, the phone will be registered and ready for use. If your phone is not
registered, you may have to register it. For more information on how to register your
phone, refer to
If the phone has successfully started up, the idle screen will be shown as below:
The idle screen shows the label of current account, time and date.
16
.
to select IP v 4 and press
to select P P PoE and press
1. PPPoE User:
to accept the change.
Account Management
1234
17 Jan 09:20
.
.
2aB
on page 43.