Switching On The Server - Fujitsu PRIMERGY TX1310 M1 Upgrade And Maintenance Manual

4.7

Switching on the server

V
CAUTION!
Before switching on the server, make sure the side cover is closed. In
●
order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and to satisfy cooling requirements,
the server must not run while the side cover is removed
Follow the safety instructions in
●
page 27.
Ê Connect all peripheral cables to the server.
Figure 16: Power button on the front panel
Ê Press the On / Off button to start up the server (1).
Ê Ensure that the LED in the On / Off button is lit green.
I
For more information see section
page 183.
Ê Perform the required procedures described in the concluding steps of each
upgrade or maintenance task.
TX1310 M1
Upgrade and Maintenance Manual
Basic hardware procedures
chapter "Important information" on
"Front panel and front USB" on
55