Replacing The Heat Sink; Preliminary Steps; Removing The Heat Sink; Installing The New Heat Sink - Fujitsu PRIMERGY TX1310 M1 Upgrade And Maintenance Manual

Processor
11.3

Replacing the heat sink

Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver

11.3.1 Preliminary steps

"Shutting down the server" on page 40
Ê
"Disconnecting the server from the mains" on page 41
Ê
"Removing the side cover" on page 42
Ê

11.3.2 Removing the heat sink

Ê Remove the heat sink as described in section
page 143.
Ê Remove the residual thermal paste from the processor surface.
Ê Clean the processor surface using a lint-free cloth.

11.3.3 Installing the new heat sink

Ê Remove the protective cover from the heat sink.
Ê Install the heat sink as described in section
page 156.

11.3.4 Concluding steps

"Installing the side cover" on page 53
Ê
"Connecting the server to the mains" on page 54
Ê
"Switching on the server" on page 55
Ê
158 Upgrade and Maintenance Manual
Hardware: 15 minutes
"Removing the heat sink" on
"Installing the heat sink" on
TX1310 M1