Fujitsu PRIMERGY TX1310 M1 Upgrade And Maintenance Manual page 216

System board and components
Ê Restore the BIOS settings manually.
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility reference manual.
"Verifying the system time settings" on page 72
Ê
"Looking up changed MAC / WWN addresses" on page 76
Ê
"Updating the NIC configuration file in a Linux environment" on page 73
Ê
"Enabling BitLocker functionality" on page 74
Ê
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer.
For further information, please refer to section
settings recovery" on page
"Using the Chassis ID Prom Tool" on page 76
Ê
Ê If applicable, restore LAN teaming configurations as described in section
"After replacing the system board" on page
216
207.
Upgrade and Maintenance Manual
"Note on network
78.
TX1310 M1