Installing 3.5-Inch Hdds; Preliminary Steps; Removing The Easyclick Rail Out Of The Bay - Fujitsu PRIMERGY TX1310 M1 Upgrade And Maintenance Manual

7.2

Installing 3.5-inch HDDs

Customer Replaceable Unit
(CRU)
Tools: tool-less
7.2.1

Preliminary steps

"Shutting down the server" on page 40
Ê
"Disconnecting the server from the mains" on page 41
Ê
"Removing the side cover" on page 42
Ê
Ê Locate the correct installation bay as described in section
information" on page
7.2.2

Removing the Easyclick rail out of the bay

Figure 33: Removing the Easyclick rails out of the bay
Ê Press the green handle of the Easyclick rail a little inwards (1) and pull the
rail out of the desired 3.5-inch HDD installation bay (2).
TX1310 M1
86.
Upgrade and Maintenance Manual
Hard disk drives
Hardware: 5 minutes
"Basic
87