Table of Contents
Advertisement
Invacare® Etude Plus
4.4.2 Britt V and Line side rails
Using a side rail height extender
Line and Britt V side rails can be supplemented by a height
extender. A side rail height extender increases the allowed
mattress thickness by 15 cm.
WARNING!
Risk of injury or death
A misapplied side rail height extender could fall
off. There's an increased risk for the user to fall
out of the bed.
– Make sure that the side rail height extender is
properly attached to the side rail. Refer to the
user manual of the side rail height extender.
– Make sure to use the correct height extender
for your side rail (the shape must match to
the shape of the side rail. A label on the
height extender determines to which side rail it
belongs. See image below.
Height extender for LINE
side rail:
16
Lock / Upper position
Pull up the top wooden side
rail bar, until the locking pin
locks with an audible click
Release
Lift the top wooden side
rail bar and press the two
locking rings together.
Down / Lower position
Lower the side rail.
Height extender for BRITT V
side rail:
4.5 Lifting pole
WARNING!
Risk of injury
The bed can tip if the handle is used, while the
lifting pole is turned away from the bed.
– The lifting pole always has to be positioned
with the handle hanging over the bed area.
– Do not exceed the maximum load of the lifting
pole; 80 kg.
4.5.1 Place the lifting pole
The lifting pole can be placed either on the left or the right
side of the head end of the bed.
1. Insert the lifting pole into the lifting pole tube and fix it
with the finger screw.
It's not required to tighten the finger screw, in case
you want the lifting pole to swing away to the side
of the bed.
4.5.2 Adjusting the handle height
The handle height should always be adjusted to the user's
need.
1.
A
1. Hold the cord out while sliding the plastic cord lock A
upwards or downwards until the handle reaches the
preferred height.
2. Lock the handle by pressing back the cord in the lock
A and pull the handle downwards.
NOTICE!
After adjusting the handle height:
– Check that the two cords above the cord lock
are parallel and inside the cord lock.
– Make sure the cord is properly locked by pulling
the handle hard.
4.6 Adjusting the leg section
Operate the leg section by lifting the mattress handle:
1. Up: Lift the mattress handle on the leg section.
2. Down: Lift the mattress handle on the leg section right
up and then lower the leg section.
2.
A
60128467-B
Advertisement
Table of Contents
