Lifting Pole; Place The Lifting Pole; Adjusting The Handle Height; Adjusting The Leg Section - Invacare Etude Plus HC User Manual

3.
Press the U-formed side rail brackets onto the top frame.
4.
Fold the finger screws forwards (under the top frame)
and up into the notches (1). Close the brackets by
turning the finger screws clockwise (2).
5. Make sure the finger screws are tightened and the side
rail properly attached (not loose).
Operating the side rail
Folding down the side rail
1. Hold the top bar of the side rail with one hand and push
the release button A with the other hand.
2. Fold down the side rail sidewards to its lowest position.
1579562-B
Folding up the side rail
1. Hold the top bar of the side rail and pull up until it locks
with a clicking sound.

4.7 Lifting pole

WARNING!
Risk of injury
The bed can tip if the handle is used, while the
lifting pole is turned away from the bed.
– The lifting pole always has to be positioned
with the handle hanging over the bed area.
– Do not exceed the maximum load of the lifting
pole; 80 kg.

4.7.1 Place the lifting pole

The lifting pole can be placed either on the left or the right
side of the head end of the bed.
1. Insert the lifting pole into the lifting pole tube and fix it
with the finger screw.
It's not required to tighten the finger screw, in case
you want the lifting pole to swing away to the side
of the bed.

4.7.2 Adjusting the handle height

The handle height should always be adjusted to the user's
need.
1.
A
1. Hold the cord out while sliding the plastic cord lock A
upwards or downwards until the handle reaches the
preferred height.
2. Lock the handle by pressing back the cord in the lock
A and pull the handle downwards.
IMPORTANT!
After adjusting the handle height:
– Check that the two cords above the cord lock
are parallel and inside the cord lock.
– Make sure the cord is properly locked by pulling
the handle hard.

4.8 Adjusting the leg section

Operate the leg section by lifting the mattress handle:
Operating the bed
2.
A
13