Setting The Pin-Code - ASCOM Eurit 33 Operating Instructions Manual

Eurit 33 plus remote access

Setting the PIN-Code

The PIN code for remote access is valid for all users.
Installation
MENU
Remote access
change
Surveillance: off
change
Remote access PIN
change
Old PIN: _
ok
1 2 3
Old PIN: 0000_
4 5 6
ok
7 9
0
New PIN: _
ok
1 2 3
New PIN: 9999_
4 5 6
ok
7 9
0
Remote access PIN
change
Note down your PIN code for safety. If you forget your PIN code, you can no longer
initiate remote access. You must reset the PIN code to the default code 0000 (see »Reset
functions«).
If you do not wish to permit remote access (block remote access), set the PIN code to
0000.
Press the menu key until »Installation« is
displayed.
û \
Press the Foxkey under \ until »Remote
access« is shown
û \
Press the Foxkey under »change«.
û \
»Surveillance« is shown in the display, followed
by the actual setting »off« or »on«.
Press the Foxkey under \ until »Remote access
û \
PIN« is shown.
Press the Foxkey under »change«.
»Old PIN:« appears.
Enter the default PIN 0000 or, if you have
already changed the PIN code, the last valid PIN
code.
Press the Foxkey under »ok«.
»New PIN:« appears.
Enter the new PIN code.
The PIN code must have four digits.
Press the Foxkey under »ok«.
û \
The new PIN code is saved.
68