Switching The Call Filter On And Off - ASCOM Eurit 33 Operating Instructions Manual

User settings

Switching the call filter on and off

If the call filter is activated, calls from numbers in the phonebook for which »no filter« has not
been defined are rejected (the caller hears the busy signal). Only calls from numbers for which
»no filter« has been set are signalled even if the call filter is activated (see »Phonebook«).
Your Eurit 33 / 33 plus is delivered with the call filter off.
Every user can switch the call filter on or off individually.
Settings
MENU
≈Call filter: off
change
≈Call filter: off
ok on
≈Call filter: on
ok off
≈Call filter: on
change
If the call filter is active, the status pictogram ≈ indicates this in the standby display.
Press the menu key until »Settings« is displayed.
Œ
û \
Press the Foxkey under \ until the display
Œ
shows »≈Call filter«
û \
Press the Foxkey under »change«.
The lower display line shows the selectable sta-
tus.
Press the Foxkey under »on« or »off«.
The newly selected status is shown in the upper
display line.
Press the Foxkey under »ok«.
Œ
û \ The call filter is switched on or off as selected.
49