Specifi Cations - Valor Portrait 530ILN Installation & Operating Instructions Manual

Approvals and Codes
This appliance is certifi ed to ANSI Z21.88–2009/CSA
2.33–2009 American National Standard/CSA Standard
for Vented Gas Fireplace Heaters for use in Canada
and USA.
The appliance complies with CSA P4.1-09, Testing
method for measuring annual fi replace effi ciencies.
The installation must conform with local codes or, in
the absence of local codes with the National Fuel Gas
Code, ANSI Z223.1or the Natural Gas and Propane
Installation Code CAN/CGA-B149. Only qualifi ed
licensed or trained personnel should install the
appliance.
The appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical
Code, ANSI/NFPA 70 or the Canadian Electrical Code,
CSA C22.1.
Ratings
Altitude (Ft)
Input Max. (Btu/h)
Input Min (Btu/h)
Manifold pressure (in.w.c.)
Min. Supply pressure (in. w.c.)
Max. Supply pressure (in. w.c.)
*Tested to CGA - 2.17-91 Gas fi red appliances for use
at high altitudes. In USA, installations may require
deration over 2000' —Check local codes.
*High Altitude Installations
Input ratings are shown in BTU per hour and are
certifi ed without deration for elevations up to 4,500 feet
(1,370 m) above sea level.
For elevations above 4,500 feet (1,370 m) in USA,
installations must be in accordance with the current
ANSI Z223.1 and/or local codes having jurisdiction.
Heating value of gas in some areas is reduced to
compensate for elevation—consult your local gas utility
to confi rm.
For installations at elevations above 4,500 feet
(1,370 m) in Canada, please consult provincial and/or
local authorities having jurisdiction.
Specifi cations
NG LPG
0-4500 *
20,500 19,000
6,500 12,500
3.5–3.9 10.3–10.7
5 11
10.5 14
Front Trims
Various fronts are available for the 530I engine. This
engine may be installed as a free standing, zero
clearance or insert application depending on which
style front trim is selected. The front trim style
affects the framing cavity, clearances and position
of the engine. A front trim kit is required for all
applications and should be on site when the engine
is installed as the parts to make the engine suitable
for zero clearance are supplied with the front trim kits
(except 549 front).
Fuel Beds
The 530I engine is available in either natural gas
or propane gas and comes equipped with either a
simulated logs, coals, or rocks fuel bed in either fuel.
Venting options
The 530I engine unit is supplied standard with a
rear direct vent outlet and may be converted to a top
direct vent outlet with no extra parts required—see
Conversion to Top Outlet for Solid Direct Vent Co-axial
Piping in the Appliance Preparation section further on
in this manual.
Direct Vent Installations (solid piping)
A list of all approved venting accessories is shown on
pages 36–37 of this manual.
Direct Vent Co-Linear Installations for Free
Standing or Recessed Installations (fl exible piping)
Converts the appliance outlet collars to accept two
3-inch diameter fl exible liners for installation into
existing solid-fuel burning fi replaces and chimneys.
Requires a co-linear adapter at the appliance and
either a co-linear terminal or co-linear-to-co-axial
terminal at the top of the chimney. A list of approved
venting accessories is shown on pages 36–37 of this
manual.
7 7