Window Refi Tting And Checking; Remote Control Initial Set-Up - Valor Portrait 530ILN Installation & Operating Instructions Manual

1. Place the window centrally against
the engine unit and resting on
the support at bottom front of the
engine.
2. Pull the clamping bars forward and
rotate inwards to secure the top of
the window.
3. Fit the two spring loaded bolts
through the bottom of the window
and tighten to secure the bottom of
the window.
4. Pull the top of the window forward
and release to ensure the springs
return it in position.
5. Similarly check the bottom of the
window by pulling it forward and
releasing.
6. Apply light hand pressure against
the window frame sides to bed in the
window seal.
The receiver and the handset of the remote control
system must be initially synchronized before the fi rst
use.
1. Insert alkaline batteries in the remote control
receiver and handset. The receiver is located left of
the control valve under the burner module.
2. With a sharp object, press and hold the receiver's
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
3. Within the subsequent 20 seconds, press the small
fl ame button ( ) on the remote handset until you
hear two short beeps confi rming the sychronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
26 26
Window Refi tting and Checking

Remote Control Initial Set-up