Removing The Power Switch; Removing The Wireless Led Board - NEC Versa P700 Disassembly Manual

3. Carefully lift the front side of the plastic cover.
4. Flip over the plastic cover along the top edge.
5. Disconnect the power switch connector shown in the next picture after having
disconnected the other end of the same cable on the main board..
6. Now remove the plastic cover and put it aside.

Removing the Power Switch

To remove the power switch, first remove the keyboard (see
remove the LED assy (see
Removing the LCD
disk drive cover (see
Removing the Touchpad), remove the heat plate (see
plastic cover (see
1. Take the plastic cover that was removed in the section Removing the Plastic Cover .
2. Turn the plastic cover up-side down.
3. Remove the one screw holding the power switch to the plastic cover and put the power
switch aside..

Removing the Wireless LED Board

To remove the wireless LED board, first remove the keyboard (see
remove the LED assy (see
Fig. 42: Disconnecting the power switch connector
Removing the LED
Display), remove the heat sink (see
Removing the Hard Disk
Removing the Plastic Cover), then perform the next steps:
Fig. 43: Removing the power switch
Removing the LED
NEC Versa P700 Disassembly Manual
Removing the
Assy), remove the LCD assembly (see
Removing the CPU), remove the Hard
Drive), remove the touchpad assembly (see
Removing the Heat
Removing the
Assy), remove the LCD assembly (see
Keyboard),
Plate), remove the
Keyboard),
Page 22
(M2x3)