Operating Time Counter; Reading The Operating Time; Display Of Total Operating Time - Electrolux TC3 Service Manual

6 OPERATING TIME COUNTER

Using a specific procedure, the operator can display the total operating time for the appliance, which is counted
from the moment it is first switched on.
The unit can count up to a maximum of 6,550 hours of operating time.

Only the operating time of normal programmes (and not diagnostic cycles) is counted.

The actual operating time for the cycle is counted (which does not include pauses, delayed start time, rinse
hold time and soaking phases).

The precision of the counter is 30 seconds per programme.

Only whole hours of operation are counted (1 hr and 59 min = 1 hr).

6.1 Reading the operating time

6.1.1 TC3 – TC2 stylings
The operations listed below must be carried out within 7 seconds.
Do not start the procedure with your fingers over the combination sensors
1. Switch on the appliance using the ON/OFF button.
2. Turn the selector clockwise until the fifth LED lights up.
3. Touch the START/PAUSE and the nearest option sensor simultaneously (as shown in the figure).
4. Keep your fingers over the sensors until the hours of operation appear on the display (at least
5 seconds).

6.2 Display of total operating time

This time is displayed with a sequence of two digits at a time: the first two digits indicate thousands and
hundreds, the second two digits indicate tens and units.
For example, if the operating time is 6,550 hours, the display will show the following sequence:
For two seconds, the
following is displayed: Hr
TC
3/2/1
At the end of phase three (after the tens and units are displayed), the cycle is repeated.
To return to normal mode, either: switch the appliance off or press a button or turn the selector knob.
Technical Support – ADL
TC3
Phase 1 Phase 2
For two seconds, the
following digits are
displayed:
 thousands (6)
 hundreds (5)
30/43
TC2
Phase 3
For the next two seconds
the following digits are
displayed:
 tens (5)
 units (0)
599 75 85-45 Rev. 00