Electrolux TC3 Service Manual page 13

End of cycle:
End of the programme is indicated by a permanently lit zero
(when the door can be opened).
Appliance stopping with water in the tub, at the end of Programmes
with the RINSE HOLD option, this is displayed by a permanently lit
zero. The LED indicating the door remains on and the LED of the
START/PAUSE sensor is turned off. The washing machine continues
to operate, rotating the drum once every 2 minutes.
Alarm code:
Indicates an anomaly during operation of the machine. Simultaneously
to the displaying of the code on the LCD display, the LED above the
START/PAUSE sensor flashes.
Calculate amount of washing:
Only for appliances with PROPORTIONAL programmes
After starting the washing programme the dot starts to flash. At this point
the washing machine calculates the amount of washing inside the drum.
When this phase ends the dot lights up fixed and the three digits display
the programme time.
Extra-rinse:
Appliances which do not feature the button and related LED for the
Extra rinse option can enable/disable this option by pressing a sensor
combination (which may be silk-screen printed on the control panel or
described in the instruction manual). This option is enabled/disabled
during programme selection and is confirmed by the related symbol
being turned on/off.
The option remains enabled even after the appliance has been turned
off (for subsequent programmes).
Technical Support – ADL
13/43 599 75 85-45 Rev. 00