Electrolux TC3 Service Manual page 26

- Door safety interlock
- Wash solenoid valve, if the
8
- Motor (55 rpm clockwise,
- Door safety interlock
- Drain pump
9
- Motor up to 650 rpm then at
- Drum rotation motor
10 - door fastening device
- Drum position sensor DSP
- Reading/deleting the last
11
- The LEDs, groups of
12
÷
- Touch a sensor to turn on the
14
(*) In most cases, the established time is sufficient to check the heating. However, the time can be increased by repeating the phase without
draining the water: pass for a moment to a different phase of the diagnostic cycle and then back to the heating control phase (if the
temperature is higher than 80°C, heating does not take place).
(**) The check at the maximum speed occurs without control of the A.G.S. and no garments must be inside the appliance.
Technical Support – ADL
water in the tub is not
enough to cover the heating
element
55 rpm anti-clockwise,
250 rpm pulse)
maximum spin speed (**)
alarm
symbols in the LCD screen
and the backlight of the
display are turned on in
sequence
group of icons in the LCD
screen or the corresponding
LED and the buzzer sounds
at the same time
Door closed
Water level above the
heating element
Door closed
Water level lower
than anti-boiling level
for spinning
Door closed
-----
Always active
26/43
Check for leaks
from the tub
Drum speed in
rpm/10
Drain, calibration
of analogue
pressure switch
Drum speed in
and spin
rpm/10
Check the
correct position
of the drum via
DSP
----
User interface
functioning
599 75 85-45 Rev. 00