Operating Time Counter; Reading Of Operating Time; Display Of Total Operating Time With Leds - Electrolux EWM2100 Service Manual

8

OPERATING TIME COUNTER

Using a specific procedure, the operator can display the total operating time for the appliance, which is counted
from the moment it is first switched on.
This option is available only on models equipped with a display. The unit can count up to a maximum of 6550
hours of operating time.
Only the operating time of normal programmes (and not diagnostic programmes) is counted
The actual operating time for the cycle is counted (which does not include pauses, delayed start time, time
of a stop with water in the drum, and soaking phases)
The precision of the counter is 30 seconds per programme
Only whole hours of operation are counted (1 hr and 59 min = 1 hr).
8.1.1

Reading of operating time

1. Switch off the appliance.
2. Press the START/PAUSE button and the nearest option button (see figure) simultaneously.
3. Holding the buttons down, switch on the appliance turning the programme selector of five positions
clockwise.
4. Hold the buttons down till the LCD or the display show the working hours (at least 5 seconds).
8.1.2

Display of total operating time with LEDs

This time is displayed two digits at a time. The first two digits indicate the thousands and hundreds. The
second two digits indicate the tens and units.
For example, if the operating time is 6550 hours, the display will show the following sequence:
Nothing is displayed for two
Styling
seconds
TC4
TC3
TC2
At the end of the phase 3 (after displaying the tens and units) the cycle repeats. To return to normal mode it is
possible to: switch the appliance off or press a button or turn the selector knob.
SOI/DT 2007-02 dmm
Phase 1 → Phase 2 →
The following digits are
displayed for two seconds:
thousands (6)
hundreds (5)
25/56
Phase 3 →
The following digits are
displayed for the next two
seconds:
a. tens (5)
b. units (0)
599 38 60-23