Electrolux TC3 Service Manual page 17

4.2.1.2 Control panel configuration
The washing programmes, the functions of the selector knob (where featured) and the various sensors
vary according to the model, since these are determined by the configuration of the appliance.
4.2.1.3 Programme selector (S1)
Description: see para. 3.1.4.1
4.2.1.4 Programme configuration
Description: see para. 3.1.4.2
4.2.1.5 Sensors
The function of each touch sensor is defined via the configuration of the appliance (the data and images are for
guidance only).
The touch sensors are positioned under the silk-screen printed symbols on the control panel (circled here in red).
A light touch on the centre of the symbol is enough to activate/deactivate the function linked to the sensor with
the switching on/off of the relative Led confirming that the enabling/disabling has taken place.
Simultaneously to the enabling/disabling of the options, the cycle duration time is updated via the digits.
You need to keep your finger pressed down for a longer period of time with the Start/Pause sensor to confirm
both the cycle's start and pause, in order to avoid unwanted starts or accidental pauses.
Every time you touch a sensor, you need to lift your finger up by a centimetre and half a second needs to
elapse before touching it again, otherwise the electronic system does not recognise that the sensor has been
touched for a second time.
The sensors used for adjusting the: Temperature, Spin, delayed Start and Time Manager have a continued
variation of values as long as your finger is in contact with the sensor.
Technical Support – ADL
S2
S1
S3
P1
S8
S11
17/43
S4
S6
S7
S5
S9 S10
599 75 85-45 Rev. 00