Alarms; Displaying The Alarms To The User - Electrolux TC3 Service Manual

5.3.1

ALARMS

5.4 Displaying the alarms to the user

When a problem occurs in the appliance, the LCD display shows a "WARNING":
In stylings TC3 and TC2 with a code (in the three digits, where the time until the end of the cycle is
represented).
In styling TC1, a message is shown (in the text line).
This information ceases to be displayed when the problem is repaired/solved. The buzzer then emits a sound
(three short "beeps"every 20" for 5 minutes). This does not occur for alarm EH0.
The alarms displayed to the user are listed below and can also be eliminated by the user:
E10 – Water fill difficulty (tap closed)
E20 – Drain difficulty (filter dirty)
E40 – Door open
EF0 – Excessive detergent
EH0 – Voltage or frequency outside normal values
While the alarm listed below:
EF0 – Water leakage (Aqua Control System)
The intervention of a service engineer is required to resolve this.
The other alarms are displayed by a code.
The alarms are enabled during the execution of the washing programme. With the exception of alarms
associated with the configuration and the power supply voltage/frequency, which are also displayed
during the programme selection phase.
The door can normally be opened (except where specified) when an alarm condition has occurred, on condition
that:
The water in the tub is below a certain level.
The water temperature is lower than 55°C.
The motor has stopped.
Certain alarm conditions require a drain phase to be performed before the door can be opened for safety
reasons:
Cooling water fill if the temperature is higher than 65°C.
Drain until the analogue pressure switch is on "empty", within a max. time of 3 minutes.
Technical Support – ADL
TC3
TC3/TC2
TC3/TC2
Check the tap
Check the drain filter
Check the door
Excessive detergent
Unstable frequency or voltage
Caution: water
27/43
TC2
TC1
TC1
599 75 85-45 Rev. 00