Electrolux TC3 Service Manual page 19

Sensor no. 11: STORING A PROGRAMME
This sensor is located beneath the sensor used to adjust the spin
speed, allowing the user to store or recall a customised
programme.
When the selected programme has been optimised with the
desired options, it can be stored in the memory, by touching the
related sensor for approximately 3 seconds. The buzzer "beeps"
once, and simultaneously the LCD display shows flashing,
to confirm the saving. This operation must be performed before you
start the wash cycle.
To recall the stored programme, simply touch the sensor,
simultaneously the LCD display shows the stored programme
with the chosen options; if no programme was stored in the
S11
memory, the LCD display does not show any change.
To make changes to the stored programme, simply: recall the
programme, make the changes and touch the sensor for three
seconds, as described previously to store the changes.
Technical Support – ADL
19/43 599 75 85-45 Rev. 00