LCD
The information described below also appears on the LCD:
Programme phases
Padlock
Door closed sensor
Hot Water:
It lights up when the possibility of filling water through the related
solenoid valve is enabled.
Washing programme time
Delayed Start:
Selected on the related sensor. After START/PAUSE or the sensor is
touched, the countdown starts and the delay time decreases hour by
hour, from a minimum delay of 2 hours to a maximum of 20 hours
( 30' 60' 90' 2hrs 3hrs... 20h 0h).
During the last 2 hours, it decreases by 30 min. at a time.
Touch the sensor in sequence to increase the delay by 30' up to
2 hours, whereas from 2 hours to 20 hours, the increase is of
1 (one) hour.
During the programme selection phase, a delayed start is possible
of between 30' and 20 hours (30' 60' 90' 10h 11h...
20h 0h) and the time is shown on the LCD display during the
last hour, the time decreases minute by minute.
To cancel the delayed start time, after the cycle has started, pause the
washing machine using the related sensor and cancel the option.
Selection incorrect
End of cycle
Alarm code
Technical Support – ADL
20/43
599 75 85-45 Rev. 00