Electrolux TC3 Service Manual page 39

Description
NTC probe for wash cycle faulty
(short-circuited or open)
Fault in NTC sensor on drying
condenser (voltage out of range,
short-circuit or open circuit)
Fault in NTC sensor on drying
duct (voltage out of range,
short-circuit or open circuit)
NTC probe for wash cycle
improperly positioned
Error in reading selector
Selector configuration error
Display board microprocessor
faulty
Technical Support – ADL
Possible fault
 Faulty wiring.
 NTC probe for wash cycle faulty.
 Main circuit board faulty.
 Faulty wiring.
 Drying NTC sensor (condenser) improperly positioned or
faulty.
 WD circuit board faulty.
 Faulty wiring.
 Drying NTC sensor (duct) improperly positioned or faulty.
 WD circuit board faulty.
 Faulty wiring.
 NTC probe for wash cycle improperly positioned.
 NTC probe faulty.
 Main circuit board faulty.
 Main circuit board faulty.
 Incorrect configuration data.
 Incorrect configuration of display board.
 If this continues, replace the display board.
The heating phase is skipped
The heating and drying phase
is skipped
Drying heating phase skipped
The heating phase is skipped
Cycle cancelled
No action to be taken
39/43
Action
Machine status
----------------
599 75 85-45 Rev. 00
Reset
START/RESET
START/RESET
START/RESET
RESET
START/RESET
START
ON/OFF
RESET
START
ON/OFF
RESET