M A S T E R A N D S E C O N D A R Y W I T H O U T T I M E R
To use the master/secondary option with Robo Slide, you must purchase the Optional Input Board (Part # Q203) and connect it to the
J2 slot of each operator (Refer to page 15).
25 VDC plug-in transformer, per gate operator required
Master
Run low voltage 16-18 gauge wire in UL approved conduit to connect operators together.
Master J2 Plug
Never run high voltage and low voltage wires in same conduit.
Master Pin 1 to Secondary Pin 1
Master Pin 2 to Secondary Pin 2
1. Make master/secondary J2 plug connections as shown above
2. Turn timers on BOTH control boards to the "OFF" position
Master Timer "OFF"
Secondary Timer "OFF"
27
Secondary
Secondary J2 Plug