Table of Contents
Advertisement
T W O - W A Y A D J U S T A B L E R E V E R S I N G S E N S O R
Adjust the
"Reverse
Sensor" on the control board. Alarm Sensor does not need to be adjusted except where noted below.
The level of reverse sensitivity depends on the weight of the gate
Sensor is set too sensitive
Sensor is not set sensitive enough
Minimum
Sensitivity
Maximum Sensitivity
and the condition of installation.
= if the gate stops in midcycle or reverses by itself.
= if the gate hits an object and does not stop or reverse.
NOW YOUR INSTALLATION IS COMPLETE
30
Important Note!
There is a
"Heavy
Gate" LED
which will light up when the gate
is heavier than normal. This is a
diagnostic LED and the operator
will still function normally when
this indicator is on.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the THE ROBO SLIDE and is the answer not in the manual?
Questions and answers