Safety Catch Rollers And Gate Rail Stops - Chamberlain THE ROBO SLIDE Instruction Manual

S A F E T Y C A T C H R O L L E R S A N D G A T E R A I L S T O P S
It is only recommended to install catch
rollers with safety covers on the side of a
post or wall with a minimal distance of half
an inch between the rollers and gate.
1/2"
End View of Gate and Wall
a t e
g G
s i n
C l o
When fully opened, the end of the sliding gate should
1/2"
stop at least five inches from an obstructing wall.
5"
NOTE: For safety reasons, physical stops MUST be installed on both ends of the gate
rail prior to installation of the gate operator. This will assure that the gate does not
derail while opening or closing fully.
DO NOT use a
Gate Catch Post.
Because the coasting distance may
vary due to changes in temperature,
it is NOT recommended to install a
stop or catch post in front of the
gates path. To do so will cause the
gate to hit the post in certain
instances.
Gate Rail Stop
7 7
a t e
g G
s i n
C l o