Operation And Maintenance; Important Safety Instructions - Chamberlain THE ROBO SLIDE Instruction Manual

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of SEVERE INJURY or DEATH:
1. READ AND FOLLOW ALL INSTRUCTIONS.
2. NEVER let children operate or play with gate controls.
Keep the remote control away from children.
3. ALWAYS keep people and objects away from the gate.
NO ONE SHOULD CROSS THE PATH OF THE MOVING
GATE.
4. Test the gate operator monthly. The gate MUST reverse
on contact with a rigid object or stop when an object
activates the non-contact sensors. After adjusting the
force or the limit of travel, retest the gate operator.
Failure to adjust and retest the gate operator properly
can increase the risk of INJURY or DEATH.
5. Use the emergency release ONLY when the gate is
not moving.
1. Disconnect power before servicing.
2. The gate area should be kept clean to insure proper
operation.
3. Make sure the reversing sensor is functioning properly.
Check it monthly (Page 30).
4. Make sure the gate track is clear of dirt, rocks or other
substances.
5. Make sure the wheels are operating smoothly on the track.
6. Oil the chain regularly with a chain lubrication oil available at
most motorcycle stores.
7. Replace blown fuses ONLY with sizes specified (Page 34).
8. Check for proper synthetic oil level in the gear box.
(10W-30 weight synthetic oil).

Operation and Maintenance

To reduce the risk of FIRE or INJURY to persons use ONLY
Chamberlain part # ABT12 for replacement battery.
WARNING
6. KEEP GATES PROPERLY MAINTAINED. Read the
owner's manual. Have a qualified service person make
repairs to gate hardware.
7. The entrance is for vehicles ONLY. Pedestrians MUST
use separate entrance.
8. Disconnect ALL power BEFORE performing ANY
maintenance.
9. ALL maintenance MUST be performed by a
Chamberlain professional.
SAVE THESE INSTRUCTIONS.
10.
9. Severe or high cycle usage will require more frequent
maintenance checks.
10. Inspection and service should always be performed anytime
a malfunction is observed or suspected.
11. When servicing, please do some "house cleaning" of the
operator and the area around the operator. Pick up any
debris in the area. Clean the operator as needed.
12. It is suggested that while at the site voltage readings be
taken at the operator. Using a Digital Voltmeter, verify that
the incoming voltage to the operator it is within ten percent
of the operators rating.
CAUTION
31