Installation Checklist - Chamberlain THE ROBO SLIDE Instruction Manual

Installation Checklist

1. Owner and Installer must read all warnings and safety precautions (Pages 2-7).
2. Make sure concrete mounting pad is big enough and deep enough for operator (Page 8).
3. Operator must be securely fastened to concrete pad (Page 8).
4. Operator chain must be 4 inch Minimum from gate. Chain must not be too tight or too loose (Page 8).
5. Gate operator should be grounded to an earth ground rod within 3 feet (Page 9).
6. Verify that both the battery and plug-in transformer are connected properly. Know where the main power disconnect plug
is to disconnect all power to operator (Page 12).
7. Verify that the gate opens and closes as needed (Page 24 & 25).
8. When gate hits object during operation, it must stop or reverse, depending on the direction gate is traveling (Page 30).
9. Make sure that any pinch point or potential entrapment are guarded by means of safety devices or like (Pages 2, 4, 5).
10. Warning placards need to be permanently mounted on both sides of gate (Page 6).
11. Test all additional equipment connected to operator.
12. Make sure all wire connections are securely fastened.
13. Review typical maintenance on operator (Page 31).
14. Schedule periodic maintenance on operator by qualified service technician.
15. Inquire about Manufacturers "operator warranty". (Warranty Card Included with operator)
16. Inquire about separate "installation warranty" with installer.
Installer Company Name, Address and Phone Number
Date of installation:
40