3-Button Control Station Wiring Connection - Chamberlain THE ROBO SLIDE Instruction Manual

3 - B U T T O N C O N T R O L S T A T I O N W I R I N G C O N N E C T I O N
IMPORTANT NOTE: The "Optional" input board (Q203) must be
used to perform this function.
There can be
3-button control station.
Cut W1 jumper at the bottom of Board
to use the stop button in the 3-button
control station.
NO common wires within this
2
4
8
16
16-Pin Plug
CAUTION
To ENSURE proper operation of external devices:
• ENSURE bare wires make good contact inside removable
terminal connections.
• DO NOT let wire insulation interfere with connection.
Open-N.O. Contact
Stop-N.C. Contact
Close-N.O. Contac
1
3
7
N.C.
19
t