Nailing Flange Assembly & Installation - kozy heat SLA-42 Installation And Operation Manual

NAILING FLANGE ASSEMBLY & INSTALLATION
1. Remove (4) nailing flanges from fireplace sides.
2. With the 1/2" (13mm) long stand-offs on nailing flanges facing away from fireplace, align nailing flange with holes on outside corners
of fireplace. Secure with screws (provided in components packet) through slots in nailing flanges.
3. Bend perforation on nailing flange until parallel with fireplace face. Do not bend toward fireplace face.
4. Position framing stud against 1/2" (13mm) long stand-off (located on backside of nailing flange). Secure with nails or screws.
NOTE Depending on facing material, tabs can be adjusted forward or back wards up to 1/2" (13mm).
CAUTION Never permanently remove these assemblies from fireplace - they must be secured in place regardless of finish material used.
When installed, nailing flanges provide the minimum 2-1/2" (64mm) clearance from fireplace sides.
AS SHIPPED
1/2" (13mm) LONG
STAND-OFF FLANGE
FRONT VIEW
Figure 8a
FIREPLACE PREPARATION
BACK VIEW
1/2" (13mm) LONG
STAND-OFF FLANGE
NAILING FLANGE
FRAMING STUD
FRONT VIEW
NAILING FLANGES
INSTALLED
TOP VIEW
FRAMING STUD
2-1/2" (64mm)
CLEARANCE
8
NAILING FLANGE