If converting to LP (propane) gas, do so now before installing light kit components.
ATTENTION
Follow instructions included with conversion kit (sold separately).
CAUTION
Disconnect all electric power from fireplace before performing this task.
NOTE
To avoid damage and prolong the life of halogen bulbs, never touch with bare hands. Always use a soft cloth when handling.
1.
Remove glass valance assembly. Page 13.
2.
Remove (10) screws securing burner cover, lift cover out of firebox.
3.
Install (6) halogen bulbs (included in components packet) into lamp
bases.
4.
Reinstall burner cover, securing with screws previously removed.
GLASS MEDIA INSTALLATION
USE ONLY #101 SERIES GLASS MEDIA (10 lbs. / 4.5 kg) IN THIS FIREPLACE.
DO NOT SUBSTITUTE MATERIALS OR USE MORE THAN SPECIFIED.
WARNING
DO NOT BLOCK PILOT ASSEMBLY WITH GLASS MEDIA!! A BLOCK PILOT MAY CAUSE DELAYED IGNITION!!
GLASS MEDIA MUST BE NO MORE THAN ONE LAYER DEEP ACROSS ENTIRE BURNER / SCREEN AREA TO
AVOID POSSIBLE DELAYED IGNITION AND/OR SOOTING ISSUES.
Install glass media onto burner assembly and pilot shield, being careful not to block pilot assembly.
DO NOT BLOCK THIS AREA
Figure 24c
LIGHT KIT
Figure 24a
Figure 24b
24
(sold separately)