Checking The Recording On The Color Video Monitor; Playback In Color; Checking The Camera Picture On The Viewfinder And/Or Color Video Monitor - Sony HDW-790 Operation Manual

3-3-2 Checking the Recording on
the Color Video Monitor — Playback
in Color
Connect an HD color video monitor with an HD-SDI input
connector to the HD-SDI OUT connector of the
camcorder. By pressing the PLAY button, you can view the
recorded picture.
HDW-790/790P
HD-SDI OUT
Notes
• If HD SDI OUT is set to OFF on the OUTPUT SEL page
of the USER menu, you cannot view the recorded
picture. Set HD SDI OUT to ON.
• When an optional HKDW-702 is installed, connect an
HD color video monitor to the HD-SDI OUT connector
located on the rear of the camcorder.
For details, see "5-3-2 Selecting Output Signals" on page
94.
When using an optional HKDW-702
extension board for down converting
Connect the color video monitor to the TEST OUT
connector or the HD-SDI OUT connector of the camcorder
located on the side of the camcorder. By pressing the
PLAY button, you can view the recorded picture.
The signal output from each connector depends on the
menu settings.
For details, see "5-3-2 Selecting Output Signals" on page
94.
52
Checking Recording and Playback
Video input
connector
1) For the output signal from the HD-SDI OUT connector, when SDI
HD monitor
2) When SD is selected as the output signal from the TEST OUT
HD-SDI input
connector
3-3-3 Checking the Camera Picture
on the Viewfinder and/or Color Video
Monitor
Usually, during playback of a tape, if you press the PLAY
button, the image sent to the viewfinder, the TEST OUT
connector, or the HD-SDI OUT connector is switched back
and forth between the camera image and the recorded
image.
However, the PB VIDEO item on the FUNCTION 2 page
of the OPERATION menu allows you to change the setting
so that the image seen through the camera is sent to the
viewfinder and the TEST OUT connector even while you
are playing back a video tape.
The HD SDI output from the HD-SDI OUT connector is
switched to that of the recorded image during playback,
regardless of the PB VIDEO setting.
To output recorded video signal to the viewfinder,
TEST OUT connector, and the HD-SDI OUT
connectors
For PB VIDEO (page 146) on the FUNCTION 2 page of
the OPERATION menu, set ALL/HDSDI to ALL.
To output the recorded video signals to the HD-
SDI OUT connector, and the camera image to the
viewfinder and the TEST OUT connector
For PB VIDEO (page 146) on the FUNCTION 2 page of
the OPERATION menu, set ALL/HDSDI to HDSDI.
NTSC/PAL monitor
SDI input
connector or
video input
1)
connector
2)
HD-SDI
OUT
is selected on the OUTPUT SEL page of the USER menu, connect
this connector to the SDI input connector. When VBS is selected,
connect it to the video input connector.
connector, connect this connector to the video input connector.
HDW-790/790P
2)
TEST OUT
1)