Sony HDW-790 Operation Manual page 158

No. Page
M05 BATTERY
M06 AUDIO-1
158
Menu List
Item Settings
BEFORE END 1 5/10/15 to 95/100%
(in 5% steps)
END 1 0/1/2/3/4/5%
BEFORE END 2 11.0 to 17.0 V
(in 0.1 V steps)
END 2 10.5 to 11.5 V
(in 0.1 V steps)
BEFORE END 3 11.0 to 17.0 V
(in 0.1 V steps)
END 3 10.5 to 14.0 V
(in 0.1 V steps)
AUDIO OUT (F/R) CUE/EE
REC AUDIO OUT EE/SAVE
CAMERA ENABL/DSABL
ADAPTER
AUDIO CH3/4 CH1/2/SW
MODE
FRONT MIC REF –60 dB/–50 dB/–40
dB
REAR MIC REF –60 dB/–50 dB/–40
dB
REAR MIC +48V ENABL/DSABL
REC AUDIO DELAY OFF/1 FLD
Default Description
5% Used when a Sony-made battery pack, such
as a BP-GL65/GL95, is used. Sets the
voltage warning level just before the battery
ends.
0% Used when a Sony-made battery pack, such
as a BP-GL65/GL95, is used. Sets the
voltage level at which the battery ends and
the camcorder stops operation, just before
the battery ends.
11.3 Used when a Sony-made battery pack, such
as a BP-L60S, is used. Sets the voltage
warning level just before the battery ends.
11.0 Used when a Sony-made battery pack, such
as BP-L60S, is used. Sets the voltage level at
which the battery ends and the camcorder
stops operation, just before the battery ends.
11.8 Used when a battery pack other than a Sony-
made one or an external power connected to
the DC IN connector is used. Sets the voltage
warning level just before the battery ends.
11.0 Used when a battery pack other than a Sony-
made one or an external power connected to
the DC IN connector is used. Sets the voltage
level at which the battery ends and the
camcorder stops operation, just before the
battery ends.
CUE Selects the audio output signal during FF/
REW.
CUE: cue audio signal
EE: Input signal
EE Selects the audio output signal during
recording.
EE: Input signal
SAVE: Not output
ENABL When a camera adaptor is connected, selects
whether or not to enable input of audio
channels 3 and 4 from the camera adaptor.
ENABL: Camera adaptor can be used.
DSABL: Camera adaptor cannot be used.
SW Selects the sources to be recorded on
channels 3 and 4.
CH1/2: Same sources as channels 1 and 2.
SW: Signals selected by the AUDIO IN CH-3/
CH-4 switches.
–50 dB Sets the reference level of the front
microphone.
–60 dB Sets the reference level when the AUDIO IN
CH1 or CH2 connector is set to MIC.
ENABL Selects whether external power is supplied to
the external microphone when AUDIO IN
CH1 or CH2 connector is set to MIC.
OFF Sets the audio recording phase.
OFF: Audio is recorder in the same phase as
the video.
1 FLD: Audio is recorded in the phase
delayed from the video by one field.