Checking The Last Three Seconds Of The Recording -Recording Review; Checking The Recording On A Color Video Monitor -Playback In Color; Checking The Camera Picture On The Viewfinder And/Or Color Video Monitor - Sony SRW-9000 Operation Manual

To automatically optimize the tracking
Select "AUTO" in step 3 of the procedure for
playback with manual tracking control.
Step 4 and following are not necessary.
When the tracking has been automatically
optimized, the tracking control is not released
even if the cassette is ejected or the system is
powered off.
Checking the Last Three Seconds
of the Recording –Recording
Review
When SYSTEM Setup >SERVO >REC
REVIEW in the VTR menu is set to NORM (the
factory default), you can review the last three
seconds of the recording. Pause the recording and
simultaneously press the FUNC and PLAY
buttons on the control panel. The last three
seconds of the recording are played back in the
viewfinder. You can also keep the FUNC +
PLAY buttons pressed to rewind the tape. The
unit rewinds the tape for as long as you keep the
buttons pressed (up to 10 seconds), and then
begins playback.
When SYSTEM Setup >SERVO >REC
REVIEW is set to ALL, you can review the whole
cut. Pause the recording and press the Func + Play
buttons. The unit rewinds to the start of the last
cut and plays it back.
The REC REVIEW function can also be assigned
to the assignable buttons.
For details, see "Assigning Functions to Assignable
Buttons/Switch" (page 50).
Note
The recording review functions only works if the
recording you have made is at least 3 seconds long.
Checking the Recording on a
Color Video Monitor –Playback in
Color
Connect an HD color video monitor with an
HDSDI input connector to the HD SDI MON1
connector or the HD SDI MON2 connector of the
camcorder. By pressing the PLAY button, you
can view the recorded picture.
The signals output from these connectors depend
on menu settings.
90 Playback – Checking the Recording
For details, see "Setting the Camera Outputs" (page
55).
HD monitor
Note
No video appears if MONITOR OUT in the <POWER
SAVE> page of the Camera >MAINTENANCE menu is
set to POWER SAVE. Set it to ACTIVE.
Checking the Camera Picture on
the Viewfinder and/or Color Video
Monitor
Normally, the signals output from the TEST OUT
connector, HD SDI MON1 connector and the HD
SDI MON2 connector switch from the camera
picture to the recorded picture during playback.
The viewfinder and an external monitor also
switch to the recorded picture. However, by
setting VF/VBS and MON on the <PB/MON
LUT> page of the OPERATION menu, you can
choose to output the camera picture even during
playback.
To output VTR playback signals to the
viewfinder, TEST OUT connector, HD SDI MON1
connector and HD SDI MON2 connector
Set VF/VBS and MON on the <PB/MON LUT>
page (see page 119) of the OPERATION menu to
ALL.
HDSDI input