Editing The User Menu - Sony HDW-790 Operation Manual

The z mark returns to a
returns to a z mark. The setting is confirmed.
8
To continue setting other items on the same page,
repeat steps 4 to 7.
Moving to another page
1
b
When the mark is placed at a position of items other
than the page number, turn the MENU knob to move
b
the mark to the page number, then push the MENU
knob.
When the z mark is positioned on the left side of the
item and a ? mark is positioned on the left of the
setting, push the MENU knob once to remove the
setting mode. Then turn the MENU knob to move the
b
mark to the page number, then push the MENU
knob.
Or, push the CANCEL/PRST / ESCAPE switch to
ESCAPE when the
items other than the page number.
A ? mark appears in front of the page number. The
camcorder is now in page selecting mode.
2
Turn the MENU knob until the desired page appears.
3
Push the MENU knob when the desired page appears.
To end menu operations
You can end menu operations using one of the following
two methods:
• Turn the MENU ON/OFF switch to OFF.
• Close the switch cover of the menu operating section.
When you close the switch cover, the MENU ON/OFF
switch is set to OFF automatically.
The menu disappears from the viewfinder screen, and the
display indicating the current status of the camcorder
appears along the top and bottom of the screen (when the
viewfinder DISPLAY switch is set to ON or the VF DISP
item on the VF DISP 1 page of the USER menu is set to
ON).
For details of the viewfinder display, see "5-2-2 Selecting
Display Items" on page 84.
78
Menu Organization and Operation
b
mark, and the ? mark
b
mark is placed at a position of

5-1-3 Editing the USER Menu

The USER MENU CUSTOMIZE menu allows you to
configure a USER menu that consists only of pages and
items that you need, by adding, deleting or replacing
pages.
Adding a new page
The USER MENU CUSTOMIZE menu allows you to add
a new page to the USER menu.
While the USER 1 EDIT page contains factory-preset
items, the USER 2 EDIT to USER 19 EDIT pages and the
ASSIGN EDIT page are all blank in their initial state. You
can register up to 10 items, including blank lines, on each
of these pages.
1
While holding down the MENU knob, move the
MENU ON/OFF switch from the OFF position to the
ON position.
The TOP menu appears.
2
Turn the MENU knob to move the
MENU CUSTOMIZE, then push the MENU knob.
If this is the first time the USER MENU CUSTOMIZE
menu has been displayed, the CONTENTS page of the
menu appears.
If the USER MENU CUSTOMIZE menu has been
used before, the page accessed last appears.
3
When the CONTENTS page is displayed, push the
MENU knob once, and then turn the MENU knob to
b
move the mark to the desired page number from
among USER 1 EDIT to USER 19 EDIT and ASSIGN
EDIT. Then push the MENU knob.
Or, turn the MENU knob until the desired page
appears, then push the MENU knob.
b
mark to USER