Table of Contents
Advertisement
1/CH-2 connectors using REAR1/WRR LEVEL (page
160) and REAR2/WRR LEVEL (page 160) on the
AUDIO-3 page of the MAINTENANCE menu.
The factory
Example 1 Example 2
setting
Audio
LEVEL (CH-1)
MIC LEVEL
level to
control
control
CH-1
Audio
LEVEL (CH-2)
MIC LEVEL
level to
control
control
CH-2
Note
When you have operation of the LEVEL (CH-1/CH-2)
controls and MIC LEVEL control linked together, if the
MIC LEVEL control is set to 0, the audio signals on
channels 1 and 2 cannot be recorded. Check the position of
the MIC LEVEL control before adjusting the LEVEL
(CH-1/CH-2) controls.
4-4-2 Manually Adjusting the Audio
Level of the Front Microphone
You can adjust the audio level input from the front
microphone connected to the MIC IN connector, which is
to be recorded on audio channels 1 and 2.
Note
When [1] and [2] are not displayed under the audio channel
level meters, the CH-1/2 / CH-3/4 switch is set to the CH-
3/4 position. Set this switch to CH-1/2.
1
To record stereo sound: Set both AUDIO IN CH-1
and CH-2 switches to FRONT.
The MIC LEVEL
control is linked
2
with LEVEL (CH-1)
control.
The MIC LEVEL
3
control is linked
with LEVEL (CH-2)
control.
Relationships between recording levels
and level controls
You can select the audio level controls to be used to adjust
the level of the front microphone using MIC CH1 LEVEL
(page 160) and MIC CH2 LEVEL (page 160) on the
AUDIO-3 page of the MAINTENANCE menu.
Audio
level to
CH-1
Audio
level to
CH-2
Note
When you have operation of the MIC LEVEL control and
LEVEL (CH-1/CH-2) controls linked together, if the
LEVEL (CH-1/CH-2) controls are set to 0, the audio
signals on channels 1 and 2 cannot be recorded. Check the
position of the LEVEL (CH-1/CH-2) controls before
adjusting the MIC LEVEL control.
To record monaural sound: Set the appropriate
AUDIO IN CH-1 or CH-2 switch corresponding to the
channel to which you want to record and adjust the
monaural sound signal to FRONT.
For detailed information on stereo or monaural
recording, see "Recording stereo sound" on page 123.
Set the AUDIO SELECT switch(es) for the desired
channel(s) selected in step 1 to MANUAL.
Turn the MIC LEVEL control, and adjust it so that the
audio level meter shows up to –20 dB for a normal
input volume.
• The 9 bars from the bottom among the 17 bars go on
with the normal input volume.
• The second top bar may turn on occasionally, but do
not allow the top bar to go on. If it goes on, the audio
level is too high.
Note
Even if a stereo microphone is connected, you cannot
adjust the levels of the L channel and R channel
separately.
The factory
Example 1
setting
MIC LEVEL
LEVEL (CH-1)
control
control
MIC LEVEL
LEVEL (CH-2)
control
control
Example 2
The MIC LEVEL
control is linked
with LEVEL
(CH-1) control.
The MIC LEVEL
control is linked
with LEVEL
(CH-2) control.
69
Adjusting the Audio Level
Advertisement
Table of Contents
