Table of Contents
Advertisement
AX1 LCD & ICON User Manual
1.0.3 ALARM REPORT
When alarm occurs, the strobe lights and the bells will be turned on. If the system is
disarmed, it could only turn off the bell but not the strobe light. Screen will be displayed as
below based on the arming type. Fast flashes indicate that the designated zone has been
triggered by alarm.
During the state of alarm, only PIN entry is allowed. In other words, only DISARM is
allowed.
1.0.4
CLEAR ALARM MEMORY
When alarm occurs, the strobe lights and the bells will be turned on. If the system is
disarmed, it could only turn off the bell but not the strobe light. Thus, the user needs to clear
the alarm memory to turn off the strobe light. Besides that, once the alarm memory is cleared,
the auxiliary power supply 1 will be reset for 3 seconds before restoring it again.
Press and hold
[
] for 2
sec.
Alarm Cleared
Rev 4.0
45
Advertisement
Table of Contents
