Alarm Report; Clear Alarm Memory - O.Y.L. Technology AX1 LED User Manual

AX1 LED User Manual

1.0.3 ALARM REPORT

When alarm occurs, the strobe lights and the bells will be turned ON. If the system is
, it could only turn OFF the bell but not the strobe light. Zone LED fast flashes
disarmed
indicate that the designated zone has been triggered by alarm.
During the state of alarm, only PIN entry is allowed. In other words, only DISARM is
allowed.
1.0.4

CLEAR ALARM MEMORY

When alarm occurs, the strobe lights and the bells will be turned on. If the system is
disarmed, it could only turn off the bell but not the strobe light. Thus, the user needs to clear
the alarm memory to turn OFF the strobe light. Besides that, once the alarm memory is
cleared, the auxiliary power supply 1 will be reset for 3 seconds before restoring it again.
Press and hold
[ ] for 2 sec.
Alarm Cleared
Rev 1.0
9