Table of Contents
Advertisement
AX1 LCD & ICON User Manual
5.2
SYSTEM CONTROL WITH BEEPER INTERFACE THROUGH CALL-IN
System answer call after
pre-set RING NUM
To Arm:
To Disarm:
To Check Alarm:
To ON Siren:
To OFF Siren:
To Bypass Zone:
To Restore Bypass Zone: [7][Zone Number][#]
To ON Output:
To OFF Output:
To Exit:
Remarks:
(i) Partition :
Press [1] to [4] for partition 1 to 4
Press [0] for all partition
(ii)Output Number
Press [0][1] to [3][2] for output 1-32
Press [0][0] for all outputs
(iii) Zone Number:
Press [0][1] to [3][2] for Zone 1-32
(iv) Check Alarm:
Once enter [3][#]:
to check next alarm report: [#] OR
Proceed with other control command
Call In
5 Slow Tones
Press [Master Pin] [#]
within 1 minutes
Acknowledgment Tone
(Beep Twice)
[1][Partition No][#]
[2][Partition No][#]
[3]#]
[4][#]
[5][#]
[6][Zone Number][#]
[8][Output Number][#]
[9][Output Number][#]
[0][#]
Rev 4.0
Valid code/
Request Accepted
Acknowledgement
Tone
(Beep twice)
Invalid Code/
Request Rejected
Error/ Reject Tone
(Long Beep)
Legend
[ ]
Phone Keypress
System respond
Action Flow
31
Advertisement
Table of Contents
