AX1 LCD & ICON User Manual
CHAPTER 4: USER PROGRAMMING
Only user who has Master PIN can access to user programming mode. If there‟s any mistake
made while programming or if the control panel rejects the command, keypad will sound an
error tone and user has to re-enter the command again. There are 10 menus in user
programming
Edit Master PIN, User PIN and Guest PIN
Master user can edit their existing Master PIN from this menu.
User can edit or delete their existing PIN or create new PIN for other users from
this menu.
User can edit their access level from this menu.
Guest can edit or delete their existing PIN from this menu.
Guest can edit their access level and guest hour from this menu.
The guest PIN is only valid when the guest time has not expired.
User 1 – Master PIN, User 2 to 7 – User PIN, User 8 – Guest PIN
Same PIN cannot be repeated to different user or guest.
PINs can be set to 4 to 6 digits.
Edit Duress Code
User can edit or delete their existing duress code from this menu.
CODE must be set in 4 digit, else error tone sound.
Edit IO Module ON Timer
This feature is to set the timer to turn ON the outputs automatically.
Timer set must be in a 12 hour format.
The system support 4 IO timers, so user can set 4 different time to turn ON the
outputs.
If IO ON setting time reach, and arming accepted, keypad will show:
Edit IO Module OFF Timer
This feature is to set the timer to turn OFF the outputs automatically.
Timer set must be in a 12 hour format.
The system support 4 IO timers, so user can set 4 different time to turn OFF the
outputs.
Edit Real Time Clock
User can edit the real time clock from this menu.
Time set must be in a 12 hour format.
Rev 4.0
50