Console Operations - BLADEZ AEROPRO H930 Owner's Manual

CONSOLE OPERATION
The console comes with 6 buttons: R (Recovery test), M (Mode), (Up or Increase), (Reset),
(Start/Stop), (Down or Decrease).
Button Functions
MODE:
In idle mode, pressing Mode button will enter program selection.
In program, Mode button is used to confirm the selection or switch the display
UP/DOWN Scrolls:
Scroll through programs before the workout or change resistance level during the workout.
Start/Stop:
This key is to start or to stop the exercise. If no speed signal is detected in 4 seconds, "P" is flashing
in the upper left corner. Pressing Start or pedaling above 30 rpm, all functions will resume. In idle
mode, pressing Start/Stop button to workout manually.
Recovery Test:
At the end of the exercise, pressing this button to test the fitness level. For a valid reading, user
must maintain pulse input during the 60 second recovery countdown test.
RESET:
Pressing Reset button will revert to the previous display. Pressing and holding for 2 seconds will
reset all functions.
Operations
Start pedaling above 30 rpm, the console will power on and flashes all elements of the LCD
momentarily.
Auto power On/Off: if there is no activity or no speed signal detected for 90 seconds, the console
automatically turns off
Programming Functions
In programming mode, a selection of MANUAL, PROGRAM, USER, H.R.C is flashing.
Use to highlight the desired program press MODE to select
Manual Mode:
At anytime, press Start/Stop to begin exercising without entering any information. Resistance can
be changed during the workout. Alternately, press Mode to set goal (Time, Distance, Calories, and
Pulse). The parameters to be set will be flashing. Press keys to set value then press
MODE to accept. Press Start to begin the exercise.
AEROPRO
12