Description Of Leds; Locating The Leds; Interface Card; Extio Unit - Matrox Extio F2208 User Manual

Description of LEDs

The LEDs on your Matrox interface card, Extio unit, and Expander unit (if present) provide status
information on your connection setup. The following describes the different LEDs:
RX (receiver) /
TX (transmitter)
Optical
connectors
Power (
Status (
* The orange LED is enabled for both the Power and Status LEDs while using the Extio Setup Utility.

Locating the LEDs

Interface card

On your interface card, the TX (transmitter) and
RX (receiver) LEDs are located next to the optical
connector on the card bracket.

Extio unit

On your Extio unit, each optical connector has
one LED. This LED is located on the side of the
optical connector and is visible through the
ventilation holes at the top of your unit. The
power and status LEDs are visible at the front of
the unit.
Red LED
No receiver or
transceiver
detected.
No optical
cable detected
or invalid
transmission.
) —
No optical
cable detected
)
or invalid
transmission.
Orange LED Green LED
Optical cable Optical cable
detected. detected.
Invalid Valid
transmission. transmission.
Optical cable
detected.
—
Valid
transmission.
Unit is
*
—
operational.
Optical cable
Optical cable
detected.
detected.
Matrox display
Matrox display
driver not
driver detected.
*
detected.
Matrox Extio Series – User Guide 23
No LED (black)
Error occured
or no power.
Error occured
or no power.
No power.
—