Connect Your Monitors; Connect The Power Supply For Your Expander Unit - Matrox Extio F2208 User Manual

WARNING: Disconnecting your optical cables while your computer is turned on will
cause your operating system, your program, and your unit to stop responding.

Connect your monitors

2
Connect your monitors to the monitor
connectors (starting with connector
the back of your Expander unit.
If your monitor has a DisplayPort
connector, connect your monitor directly to
a DisplayPort connector at the back of your
unit.
If your monitor has a DVI-D connector, use
a DisplayPort to DVI-D adapter to connect
your monitor cable to the DisplayPort
connector at the back of your unit.
WARNING: To avoid damaging the
DisplayPort connector on your DisplayPort
monitor cable or on your Matrox product,
carefully remove the DisplayPort cable by
pressing the latch on the top of the DisplayPort
connector while removing the connector.
Connect the power supply for
3
your Expander unit
Attach one end of the power supply cable
provided with your Matrox product to the
power connector on your Matrox product.
Plug the power supply cord into an electrical
outlet.
Your Matrox Expander unit is now connected. Restart your computer and install your Matrox
software (see "Installing your Matrox software", page
Monitor
connector
(DisplayPort)
) at
1
Monitor
connector
(DVI-D)
Power
supply
cable
20).
Matrox Extio Series – User Guide 19
DisplayPort to
DVI-D adapter