Set Up A Site-To-Site Vpn; Specify The Site-To-Site Vpn Connection - NETGEAR Sprint 6100D User Manual

•
SIT_IDENTITY_ONLY
•
Initial Contact
•
Enable MODE_CFG
•
Request Certificate
•
Send Certificate
•
Unique SAs
•
IKE Fragmentation

Leave NAT-T set to Disable and the Action after connection timeout set to Give up.
16. Close the Edit Connection window. The settings are saved.
17. In the main screen, highlight the connection name and select Start.
Once the connection is established, the icon to the right of the connection name turns green.
The client computer can access the LAN-side resources of the gateway including the web
management interface of the gateway.

Set Up a Site-to-Site VPN

This example describes how to set up a site-to-site VPN tunnel between two gateways at
different locations. The LAN subnets of these two gateways must each be in a unique range.
To do this, you must complete the following tasks:
1. Make sure that each gateway uses a different subnet range and that the ranges do not
overlap.
2. Specify the VPN connection for each gateway.
3. Enable the VPN on each gateway.

Specify the Site-to-Site VPN Connection

To specify the VPN connection information:
1. On the first gateway, select Settings > General > VPN.
2. In the Site-to-Site VPN configuration section, click the Edit button next to the Pre-Shared
Key (PSK) field.
3. Type a unique pre-shared key.
Note: The key is an alphanumeric string with a maximum length of 32 characters.
Set up a Virtual Private Network (VPN) 110