Set Up A Client-To-Gateway Vpn Configuration; Configure The Vpn Client On The Remote Computer - NETGEAR CG3000DCR User Manual

Set Up a Client-to-Gateway VPN Configuration

Setting up a VPN between a remote computer running the VPN client and a network gateway
involves these two steps:
1. Configure the VPN tunnel between the remote computer and the network gateway.
2. Configure the VPN client endpoint.
Table 3. Sample client-to-gateway VPN tunnel
VPN Tunnel Configuration
Connection Name
Pre-Shared Key
Secure Association
Perfect Forward
Secrecy
Encryption Protocol
Authentication
Protocol
Diffie-Hellman (DH)
Group
Key Life in seconds
IKE Life Time in
seconds
VPN Endpoint
Client
CG3000DCR

Configure the VPN Client on the Remote Computer

This overview assumes that the computer running the client has a dynamically assigned IP
address. The computer must have a VPN client program installed that supports IPSec.

To configure the VPN client:
1. Add a connection.
2. Configure the security policy in the VPN client software.
3. Configure the VPN client identity.
4. Configure the VPN client authentication.
CG3000DCR Advanced Cable Modem Gateway
RoadWarrior
12345678
Main
Disabled
3DES
SHA-1
Group 2
28800 (8 hours)
3600 (1 hour)
Local IPSec ID LAN IP Address
toCG3000D —
toClient 192.168.3.1
Subnet Mask
—
255.255.255.0
VPN
32
FQDN or
Gateway IP 
(WAN IP Address)
Dynamic
22.23.24.25