NETGEAR Sprint 6100D User Manual page 113

•
Encryption: Select 3DES.
•
Authentication: Select SHA-1.
•
Key Group: Select DH2 (1024).
7. Click the Advanced tab.
8. Specify these settings in the Advanced screen:

In the Advanced Features section, select the Mode Config check box and leave the
other settings as shown.

In the X-Auth section, specify how the client user enters credentials:
•
To enable a pop-up, select the X-Auth Popup check box.
With this setting, the client opens a pop-up window prompting the user to enter
the user name and password.
•
To avoid using a pop-up, clear the X-Auth Popup check box and type the user
name and password in the Login and Password fields.

Leave the Local ID field and Remote ID field blank.
9. Under the Gateway heading, select Tunnel, and click the IPSec tab.
10. Specify these settings on the IPSec screen:

In the Address type list, select Subnet Address.

In the Remote LAN address and Subnet mask fields, enter the gateway IP address
and subnet mask.
Note: The gateway and the client's network must have different subnet ranges that
do not overlap.

In the ESP section, specify the following:
•
Encryption. Select 3DES.
•
Authentication. Select SHA-1.
•
Mode. Select Tunnel.

In the PFS section, specify the following:
•
Select the PFS check box.
•
In the Group list, select DH2(1024).
11. Leave the rest of the tabs with their default values.
Set up a Virtual Private Network (VPN) 106