Installing The Fillers; Installing Fillers For Eia-232/Rs-485 Printers - IBM SUREMARK TF6 User Manual

4. Connect the cables to the printer.
5. Place the SureMark printer on the two bracket posts. Slide the printer down until
Wall bracket
Mounting posts
Screws (not provided)
SureMark with top cover open
Figure 12. Mounting a single-station SureMark on a wall

Installing the fillers

Installing fillers for EIA-232/RS-485 printers

Notes:
1. On an integrated unit, pull out on the locking lever at the left side of system unit.
2. Ensure that the side of each filler overlaps the tab on the side of the system
To install fillers:
1. Power the system off and disconnect the EIA-232 power supply (if connected).
2. If you have a video display on an integrated system:
24
SureMark Printers User's Guide
a click sounds.
unit.
See Figure 5 on page 18.
a. Move the display on its arm to the side and remove any tape holding the
alignment ring.
b. Remove the knockout section of the display filler.
c. Align the display filler with the alignment ring and slide the filler onto the
ring. Press the display filler into place. See Figure 13 on page 25.
Updated April 2, 2009